AEG FAVORIT 40860 i 사용자 지침 - 페이지 35

{카테고리_이름} AEG FAVORIT 40860 i에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG FAVORIT 40860 i 44 페이지. Aeg dishwasher user manual
AEG FAVORIT 40860 i에 대해서도 마찬가지입니다: 사용자 정보 (48 페이지)

페이지 인쇄

Connecting the Dishwasher

Water Connection

The dishwasher is fitted with safety devices that prevent the return of

wash water into the drinking water system and comply with the appli-

cable plumbing regulations.

• The dishwasher can be connected to cold and hot water supplies up

to max. 60 °C.

• The dishwasher must not be connected to open hot water appliances

or instantaneous water heaters.

Permitted water pressure

Lowest permitted water pressure:

1 bar (=10N/cm2 =100 kPa)

Highest permitted water pressure:

10 bar (=100 N/cm2 =1 MPa)

Connect the inlet hose

The water inlet hose must not be kinked, crushed or entangled when it

is being connected up.

Connect the threaded hose fitting (DIN 259) on the water inlet hose to

a tap with an external thread (¾ inch). Tighten the threaded hose fit-

ting only by hand.

• In order that access to the tap in the kitchen is not limited by the use

of the dishwasher, we recommend the installation of an additional

tap, or the fitting a two way adapter to the existing tap.

• If you need a longer water inlet hose than that supplied, the follow-

ing VDE approved complete hose sets are to be used, these are availa-

ble from your dealer:

– Hose set "WRflex 100" (E No.: 911 239 034)

– Hose set "WRflex 200" (E No.: 911 239 035)

Installation and Connection Instructions

For a water pressure of less than 2 bar

please seek advice from customer service.

In the case of a water pressure greater

than 10 bar, a pressure reduction valve

must be used (available from your

dealer).