Garmin VHF 100 series 설치 지침 매뉴얼 - 페이지 7
{카테고리_이름} Garmin VHF 100 series에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin VHF 100 series 10 페이지. Marine vfn radio
Garmin VHF 100 series에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (2 페이지), 적합성 선언 (5 페이지)
페이지 인쇄
4. Add additional T-connectors for each device you want to add to the NMEA 2000 network, and connect each device to a T-connector with
a drop cable.
5. Connect terminators (not included) to each end of the combined T-connectors.
NMEA 2000 PGN information
Use this table to determine the approved NMEA 2000 PGN information that can be received and transmitted by a VHF 200 series radio
when communicating with a NMEA 2000-compliant device.
Receive
059392
ISO Acknowledgment
059904
ISO Request
060928
ISO Address Claim
126208
NMEA - Command/Request/Acknowledge Group Function
129026
COG (course over ground) and SOG (speed over ground)
- Rapid Update
129029
GNSS (Global Navigation Satellite System) Position Data
Garmin VHF 200 Series radios are NMEA 2000 certified.
Connecting the VHF 200 Series Radio to a Hailer Horn (Optional)
The radio can be connected to a hailer horn that will allow using the microphone or the GHS 10 handset to make announcements through
your public address system.
To mount the hailer horn, refer to the installation instructions that came with the device. Mount the hailer horn at least 10 ft. (3 m) away
from the microphone and facing away from the microphone to avoid feedback.
To connect the VHF 200 series radio to a hailer horn:
1. Attach the included 23 in. (600 mm) hailer cable to the cable on the rear panel of the radio by connecting the red RCA plug into the red
jack.
2. Connect the white wire on the other end of the hailer cable to the positive (+) connection on the hailer.
3. Connect the black wire to the negative (-) connection on the hailer.
CAUtIoN: Cover the connections with a waterproof, adhesive tape, such as rubber vulcanizing tape, to prevent water from
seeping into the radio.
Refer to the VHF 100/200 Series Owner's Manual to operate the hailer.
VHF 100/00 Series Radio Installation Instructions
Ignition or in-line
switch
Fuse
-
+
1 Vdc battery
Power cable
Female
terminator
Creating a Basic NMEA 2000 Network
NMEA 000
Drop cable
T-connectors
terminator
Transmit
059392
ISO Acknowledgment
060928
ISO Address Claim
126208
NMEA Request/Command/
Acknowledge Group Function
126464
PGN List
126996
Product Information
129799
Radio Frequency/Mode/Power
129808
DSC Call Information
device
Male