AEG FAVORIT 43470 I 사용자 정보 - 페이지 30

{카테고리_이름} AEG FAVORIT 43470 I에 대한 사용자 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG FAVORIT 43470 I 36 페이지. Aeg dishwasher favorit

Installation and connection instructions

Water outlet hose connection

The end of the drain hose can be connected in the following ways:

1. To the sink outlet spigot, securing it to the underside of the work

surface. This will prevent waste water from the sink running into the

machine.

2. To a stand pipe provided with vent-hole, minimum internal

diameter 4 cm.

The waste connection must be at a height of between 30 cm

(minimum) and 100 cm (maximum) from the bottom of the

dishwasher.

The drain hose can face either to the right or left of the dishwasher

Ensure the hose is not bent or squashed as this could prevent or slow

down the discharge of water.

The sink plug must not be in place when the machine is draining as

this could cause the water to siphon back into the machine.

If you use a drain hose extension it must be no longer than 2 metres

and its internal diameter must be no smaller than the diameter of the

hose provided.

Likewise the internal diameter of the couplings used for connections

to the waste outlet must be no smaller than the diameter of the hose

provided.

Attention!

Our appliances are supplied with a security device to protect against

the return of dirty water back into the machine.

If the spigot of your sink has a "no return valve" incorporated this can

prevent the correct draining of your dishwasher.

We advise you therefore to remove it.

CS18