AEG FAVORIT 44070 i 사용자 정보 - 페이지 30

{카테고리_이름} AEG FAVORIT 44070 i에 대한 사용자 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG FAVORIT 44070 i 36 페이지. Aeg dishwasher
AEG FAVORIT 44070 i에 대해서도 마찬가지입니다: 사용자 정보 (36 페이지)

페이지 인쇄

Connecting the dishwasher

Connecting to the water supply

• The dishwasher can be connected to cold and hot water supplies up

to max. 60°C.

• The dishwasher must not be connected to open hot water appliances

or instantaneous water heaters.

Permitted water pressure

Lowest permitted water pressure:

1 bar (=10 N/cm2 =100 kPa)

Highest permitted water pressure:

10 bar (=100 N/cm2 =1 MPa)

Connecting the inlet hose

The water inlet hose must not be kinked, crushed or entangled when it

is being connected.

Connect the threaded hose fitting (ISO 228-1:2000) on the water inlet

hose to a tap with an external thread (¾ inch). The inlet hose is fitted

with either a plastic or a metal nut:

– Only tighten the plastic nut hand tight.

– You must tighten the metal nut using a tool.

Then do a visual check for water tightness (make sure that the tap is

not dripping).

• So that access to the tap in the kitchen is not restricted by the use of

the dishwasher, we recommend installing an additional tap, or fitting

a T-branch to the existing tap.

If you need a longer water inlet hose than that supplied, the following

VDE-approved complete hose sets are to be used. These are available

from your local dealer.

– Hose kit "WRflex 100" (Code: 911 239 034)

– Hose kit "WRflex 200" (Code: 911 239 035)

Consult your plumber if the water pres-

sure is less than 1 bar.

If the water pressure is greater than 10

bar, a pressure reduction valve must be

used (available from your dealer).