Garmin GTX 320 설치 매뉴얼 - 페이지 19
{카테고리_이름} Garmin GTX 320에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GTX 320 43 페이지. Garmin gtx 320/320a transponder installation manual
Garmin GTX 320에 대해서도 마찬가지입니다: 유지 관리 매뉴얼 (24 페이지), 파일럿 매뉴얼 (4 페이지), 설치 매뉴얼 (37 페이지)
페이지 인쇄
2.8 Installation Using Existing Bendix/King KT 76A/78A Installation Rack
The GTX 320 and GTX 320A can be used with an existing Bendix/King KT 76A/78A installation rack by using
the KT 76A/78A Installation Adapter (P/N 011-00289-00). See figure B7 for the Bendix/King KT 76A/78A
Adapter assembly drawing.
GTX 320 units that are at Mod Level 1 must use the Mod Level 1 Bendix/King KT 76A/78A
Installation Adapter. After Mod Level 1, the GTX 320 sits 0.17" (4.3 mm) closer to the instrument
panel. Also, when installing the GTX 320 in an existing Bendix/King KT 76A/78A rack (using the
KT 76A/78A Adapter) and when the aircraft has a bus voltage of +28 VDC, make sure the +28 VDC
dropping resistor is bypassed.
A.
Attach the KT 76A/78A installation adapter to the rear of the GTX 320 using the two captive screws
on the adapter.
B.
Looking at the bottom of the transponder, make sure the front lobe of the locking mechanism is in a
vertical position. This can be accomplished by using a 3/32" Allen wrench through the face plate.
C.
Slide the unit into the rack until the front lobe of the unit touches the rack. Guide pins on the back
plate will help in the proper alignment of the unit in the rack.
D.
Turn the Allen wrench clockwise until unit is secured in the rack. Continue turning until tight. Do
not overtighten the screw.
E.
To remove the unit from the rack, turn the 3/32" Allen wrench counterclockwise until it disengages
from the rack.
GTX 320/320A Installation Manual
190-00133-01
NOTES
Page 2-9
Rev M