Garmin GTX 320 ATC 유지 관리 매뉴얼 - 페이지 20

{카테고리_이름} Garmin GTX 320 ATC에 대한 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GTX 320 ATC 24 페이지. Atc transponder

3.3.3.13 SBY (Stand By)

Set the transponder mode select switch to the SBY position. The "SBY" nomenclature and the four

reply code digits shall be illuminated with a higher intensity than the "OFF", "ON", "ALT" and "TST"

nomenclature. All internal power supplies shall be on but the unit shall not reply to any interrogations.

3.3.3.14

Set the transponder mode select switch to the ON position. The "ON" nomenclature and the four reply

code digits shall be illuminated with a higher intensity than the "OFF", "SBY", "ALT" and "TST"

nomenclature.

3.3.3.15 ALT (Altitude)

Set the transponder mode select switch to the ALT position. The "ALT" nomenclature and the four

reply code digits shall be illuminated with a higher intensity than the "OFF", "SBY", "ON" and "TST"

nomenclature.

3.3.3.16 TST (Test)

1. Decrease the RF level control on the ATC-1400A so that the transponder has a 00% reply rate.

2. Rotate and hold the transponder mode select switch in the TST position. "TST", "OFF", "SBY",

"ON" and "ALT" nomenclature shall all be illuminated at the reduced level. The four reply code digits

shall remain illuminated with no change in intensity. The triangle-shaped reply light must turn on and

remain on while the switch is held in the TST position.

3. Release the mode select switch from the TST position. It shall freely snap back to the ALT position

and the triangle-shaped Reply Light shall turn off.