Garmin GTX 330 파일럿 매뉴얼 - 페이지 9

{카테고리_이름} Garmin GTX 330에 대한 파일럿 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GTX 330 13 페이지. Equipment supplement
Garmin GTX 330에 대해서도 마찬가지입니다: 파일럿 매뉴얼 부록 (50 페이지), 파일럿 매뉴얼 부록 (50 페이지), 파일럿 매뉴얼 (12 페이지), 파일럿 매뉴얼 (8 페이지), 파일럿 매뉴얼 (6 페이지), 파일럿 매뉴얼 (13 페이지), 매뉴얼 (8 페이지), 설치 매뉴얼 (49 페이지)

Entering a Flight ID Number

When configured for FLT ID PWR-UP ENTRY at installation, the flight crew must enter

the Flight ID before the GTX 330 will operate. After the flight crew enters the correct Flight

ID, the aircraft identification that is transmitted in response to ATC radar interrogations is

properly correlated with the associated call sign for voice communication with the aircraft.

If the FLT ID PWR-UP ENTRY is required but does not appear at power up, contact a

Garmin authorized service center for GTX 330 configuration.

No space is needed when entering Flight ID characters. When a Flight ID contains a

space, the GTX 330 automatically removes the spaces upon completion of Flight ID entry.

At system power-up the FLT ID may

appear with no number (as shown) or with the

last FLT ID entered. The cursor covers the

entire FLT ID field.

If the Flight ID appearing at turn-on is

correct, press the CRSR key to move the cursor

to the OK? field. Press CRSR again to accept

the FLT ID. The transponder then begins

normal operation.

When no FLT ID appears or the FLT

ID must be changed, press the number keys

corresponding to the alphanumeric character

entry. For example, to enter the letter R press

the 5 key four times.

Each time an alphanumeric character is entered, press the CRSR key to move the cursor

to the next blank field. Pressing the CLR key moves the cursor back to the previous character.

After the complete FLT ID is entered, press the CRSR key to move the cursor to the OK? field.

Press CRSR again to accept the FLT ID.

When FLT ID entry is complete the transponder begins normal operation.

If an error is made while entering a FLT ID, press the CLR key to back up to any point,

including highlighting the OK? field. If an incorrect FLT ID is discovered after the unit begins

operation, turn the GTX 330 off. Then turn it back on and reenter the correct FLT ID.