Garmin GTX 330 파일럿 매뉴얼 - 페이지 5

{카테고리_이름} Garmin GTX 330에 대한 파일럿 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin GTX 330 13 페이지. Equipment supplement
Garmin GTX 330에 대해서도 마찬가지입니다: 파일럿 매뉴얼 부록 (50 페이지), 파일럿 매뉴얼 부록 (50 페이지), 파일럿 매뉴얼 (12 페이지), 파일럿 매뉴얼 (13 페이지), 파일럿 매뉴얼 (8 페이지), 파일럿 매뉴얼 (6 페이지), 매뉴얼 (8 페이지), 설치 매뉴얼 (49 페이지)

Code Selection

Code selection is done with eight keys (0 – 7) providing 4,096 active identification codes.

Pushing one of these keys begins the code selection sequence. Digits that are not yet entered

appear as dashes. The new code is activated when the fourth digit is entered. Pressing the CLR

key moves the cursor back to the previous digit. Pressing the CLR key when the cursor is on

the first digit of the code, or pressing the CRSR key during code entry, removes the cursor and

cancels data entry, restoring the previous code. You may press the CLR key up to five seconds

after code entry is complete to return the cursor to the fourth digit. The numbers 8 and 9 are not

used for code entry, only for entering a Count Down time, and for adjusting contrast and display

brightness.

When the transponder code is changed, a notification is sent to ATC by the GTX 330.

This notification is temporary and will not be sent if the GTX is inactive (i.e., set to STBY)

when the code is changed.

NOTE: On a dual transponder installation, change the code on the active

transponder. This ensures the notification is transmitted to ATC.

Keys for Other GTX 330 Functions

IDENT Pressing the IDENT key activates the Special Position

Identification (SPI) Pulse for 18 seconds, identifying your transponder

return from others on the air traffic controller' s screen. The word IDENT

will appear in the upper left corner of the display during this time.

VFR Sets the transponder code to the pre-programmed VFR code

selected during installation configuration (this is set to 1200 at the

factory). Pressing the VFR key again restores the previous identification

code. If the VFR Key is pressed when disabled (dependent upon

installation configuration) a VFR Key Disabled message appears to

indicate that no operation took place.

FUNC Changes the page shown on the right side of the display.

Display data includes Pressure Altitude, Flight Time, Altitude Monitor,

Count Up, and Count Down timers. Also displays Outside Air

Temperature, Density Altitude, Contrast, Display, and ADS-B Operation

(dependent upon installation configuration).

START/STOP Starts and stops the Altitude Monitor, Count Up,

Count Down, and Flight timers.