Garmin VHF 200i 설치 지침 매뉴얼 - 페이지 6
{카테고리_이름} Garmin VHF 200i에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin VHF 200i 10 페이지. Marine vfn radio
Garmin VHF 200i에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (2 페이지), 안전 및 제품 정보 (20 페이지), 적합성 선언 (5 페이지)
페이지 인쇄
Connecting a VHF 200 Series Radio to a NMEA 2000 network
The VHF 200 and VHF 200i radios can be connected to your existing NMEA 2000 network, or you can build a basic NMEA 2000 network
to connect to another NMEA 2000-compatible device, such as a chartplotter. For more information on NMEA 2000 and to purchase
required connectors, visit www.garmin.com.
Note: The VHF 100 and VHF 100i radios cannot be connected to a NMEA 2000 network. See
network.
To connect the VHF 200 series radio to your existing NMEA 2000 network:
1. Determine where you would like to connect the radio to your existing NMEA 2000 backbone.
2. Disconnect one side of a NMEA 2000 T-connector from the backbone at an appropriate location.
If you need to extend the NMEA 2000 backbone, connect an appropriate NMEA 2000 backbone extension cable to the side of the
T-connector you disconnected.
3. Add a T-connector (not included) for the radio in the NMEA 2000 backbone by connecting it to the side of the T-connector you
disconnected.
4. Route a NMEA 2000 drop cable (not included) to the bottom of the T-connector added in step 3 to your NMEA 2000 network. Use a drop
cable with a length up to 20 ft. (6 m).
5. Connect the drop cable to the T-connector and the NMEA 2000 port on the radio
CAUtIoN: If you have an existing NMEA 2000 network on your boat, it should already be connected to power. Do not connect an additional
NMEA 2000 power cable to an existing NMEA 2000 network, because only one power source should be connected to a NMEA 2000 network.
To create a basic NMEA 2000 network:
1. Connect two T-connectors (not included) together by their sides.
2. Connect a NMEA 2000 power cable (not included) to one of the T-connectors.
CAUtIoN: A NMEA 2000 power cable must be connected to a 12 Vdc power source through a switch. The VHF 200 series radio may drain your
battery if it is connected directly. Connect the cable to the ignition switch of the boat if possible, or through an appropriate additional switch.
3. Connect a NMEA 2000 drop cable (not included) to the other T-connector and to the NMEA 2000 port on the radio.
6
NMEA 000 port
Other NMEA
000 device
T-connectors
Connecting the VHF 200 Series Radio to an Existing NMEA 2000 Network
page 5
VHF 00 series
radio
NMEA 000
chartplotter
Drop cable
NMEA 000
backbone
VHF 100/00 Series Radio Installation Instructions
to connect your radio to a NMEA 0183