Garmin VHF 315 Series 소유자 매뉴얼 - 페이지 24

{카테고리_이름} Garmin VHF 315 Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Garmin VHF 315 Series 32 페이지.
Garmin VHF 315 Series에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (6 페이지), 설치 지침 매뉴얼 (15 페이지)

페이지 인쇄

Automatic Transmitter Identification System

Automatic Transmitter Identification System (ATIS) is a vessel identification system used on certain inland

waterways in some European countries. See your Garmin dealer to program your VHF radio if you plan to use

your radio on waterways that are within the bounds of the Regional Arrangement Concerning the

Radiotelephone Service on Inland Waterways (the Basel Agreement). ATIS is prohibited outside the European

inland waterways that are covered by the Basel Agreement.

When you enable ATIS, your radio sends a data signal identifying your station at the end of every transmission.

Data identifying your position is not sent, but your position is calculated through the method of triangulation by

coastal stations that receive your transmissions.

To enable ATIS, you must enter your ATIS identification number

page

20), and turn on ATIS

ATIS identification number and to learn about ATIS requirements for your region.

Your radio disables these functions when you enable ATIS.

• Digital Selective Calling (DSC)

• Monitor two or three channels (Dual watch and Tri watch)

• Scanning channels

International channels 6, 8, 10, 11, 12, 13, 14, 71, 72, 74, and 77 restrict transmitting to low-power (1 W) when

you enable ATIS.

Entering Your ATIS Identification Number

You can enter your ATIS identification number only once. If you must change your ATIS identification number

after entering it, you must take your radio to your Garmin dealer for reprogramming.

NOTE: You can access the ATIS settings on the radio after the ATIS feature is activated by your Garmin dealer.

1 Select MENU > ATIS > MY ATIS ID.

2 Enter your ATIS number

3 Select ACCEPT.

The radio prompts you to reenter your number.

4 Enter your ATIS number again, and select ACCEPT.

If the ATIS numbers do not match, a message appears.

5 If necessary, select RETRY, and enter the number again.

Turning On and Off ATIS

1 Select MENU > ATIS > ATIS.

2 Select ON or OFF.

appears on the screen when ATIS is enabled.

3 Select OK.

Viewing Your ATIS Identification Number

Select MENU > ATIS > MY ATIS ID.

(Turning On and Off ATIS, page

(Entering Text, page

9).

(Entering Your ATIS Identification Number,

20). See your Garmin dealer to determine your

NOTICE

Automatic Transmitter Identification System