AEG FAVORIT 50874 사용자 설명서 - 페이지 21

{카테고리_이름} AEG FAVORIT 50874에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG FAVORIT 50874 28 페이지. Electrolux dishwasher favorit 50874

페이지 인쇄

Malfunction

After the check, switch on the appliance. The programme continues from the point of

interruption.

If the malfunction shows again, contact the service centre.

If the display shows other fault codes, contact the service centre.

The necessary data for the service centre is on the rating plate.

We recommend that you write the data here:

Model (MOD.)

Product number (PNC)

Serial number (S.N.)

The washing results and drying results are not satisfactory

Problem

The dishes are not clean.

Limescale particles on the

dishes.

There are streaks, milky stains,

or a bluish layer on glasses and

dishes.

Fault code

Blow out fuse in the

household fuse box.

The delay start is set.

Possible cause

The selected washing pro-

gramme was not applicable for

the type of load and soil.

The baskets were not loaded

correctly, water did not touch

all surfaces.

The spray arms could not turn

freely because of incorrect ar-

rangement of the load.

The filters are dirty or not as-

sembled and installed correct-

ly.

The quantity of detergent was

not sufficient or missing.

The salt container is empty.

Incorrect water softener ad-

justment

The salt container cap is not

closed correctly.

Rinse aid dosage is too high.

What to do if...

Possible cause

Replace the fuse.

If you want to cancel

the delay start, refer to

'Select and start a

washing programme'.

....................

Possible solution

Make sure that the washing

programme is applicable for the

type of load and soil.

Load the baskets correctly.

Make sure that an incorrect ar-

rangement of the load does not

cause a blockage of the spray

arms.

Make sure that the filters are

clean and correctly assembled

and installed.

Make sure that the quantity of

detergent is sufficient.

Fill the salt container with dish-

washer salt.

Adjust the water softener.

Make sure that the salt con-

tainer cap is closed correctly.

Decrease the rinse aid dosage.

Possible solution