AEG FAVORIT 64470 I 사용자 정보 - 페이지 23
{카테고리_이름} AEG FAVORIT 64470 I에 대한 사용자 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG FAVORIT 64470 I 36 페이지. Aeg dishwasher
페이지 인쇄What to do when...
Remedying minor faults
If one of the following fault codes is displayed in the multi-display
during operation:
- Fault code
- Fault code
please have a look at the following table.
When the fault is remedied, close the dishwasher if necessary, press the
button for the programme that has started. The programme will
continue.
With other fault codes:
- Cancel the programme.
- Switch the appliance off and on again.
- Re-set the programme.
In the fault is displayed again, please contact your local Service Force
Centre and inform them of the fault code.
Malfunction
The indicator for the
selected programme is
flashing:
Error code
displayed in the multi-
display: There is no water
running into the
dishwasher.
(Problems with water inflow),
(Problems with water outflow),
Possible cause
The tap is blocked or
furred with limescale.
The tap is turned off.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked
is
Filters in the base of the
washing compartment are
blocked.
The water inlet hose has not
been correctly laid.
Operating instructions
Remedy
Clean tap.
Turn the tap on.
Clean the filter in the
threaded hose fitting.
Press the button for the
selected programme;
then cancel the programme
by pressing RESET (see
chapter: Starting a
programme); Clean out the
filters. (See chapter:
Cleaning the filters).
Check hose installation.
23