Brother DCP-130C 사용자 설명서 - 페이지 39

{카테고리_이름} Brother DCP-130C에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother DCP-130C 47 페이지. Windows vista
Brother DCP-130C에 대해서도 마찬가지입니다: 사양 시트 (2 페이지), 빠른 설정 매뉴얼 (22 페이지), 빠른 설정 매뉴얼 (22 페이지), 설정 매뉴얼 (23 페이지), 빠른 설정 매뉴얼 (24 페이지), 빠른 설정 매뉴얼 (15 페이지)

페이지 인쇄

Checking the printing

alignment

Press Ink Management.

Press a or b to choose Test Print.

Press OK.

Press a or b to choose Alignment.

Press OK.

Press Mono Start or Colour Start.

The machine starts printing the

Alignment Check Sheet.

Is Alignment OK?

aYes bNo

Check the 600 dpi and 1200 dpi test

prints to see if number 5 most closely

matches number 0.

If the number 5 sample of both the

600 dpi and 1200 dpi are the best

matches, press a (Yes) to finish

Alignment Check, and go to step h.

If another test print number is a

better match for either 600 dpi or

1200 dpi, press b (No) to choose it.

For 600 dpi, press a or b to select the

number of the test print that most closely

matches the number 0 sample (1-8).

600dpi Adjust

Select Best #5

Press OK.

For 1200 dpi, press a or b to select the

number of the test print that most closely

matches the number 0 sample (1-8).

1200dpi Adjust

Select Best #5

Press OK.

Press Stop/Exit.

Troubleshooting and Routine Maintenance

Packing and shipping

the machine

CAUTION

It is important to allow the machine to 'park'

the print head after a print job. Listen

carefully to the machine before unplugging

it to make sure that all mechanical noise

has stopped. Not allowing the machine to

finish this parking process may lead to print

problems and possible damage to the print

head.

Open the ink cartridge cover.

Pull the lock release levers down and

take out all the ink cartridges. (See

Replacing the ink cartridges on page

32.)