AEG FAVORIT 65070 Vi 사용자 정보 - 페이지 37

{카테고리_이름} AEG FAVORIT 65070 Vi에 대한 사용자 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG FAVORIT 65070 Vi 44 페이지. Aeg the fully integratable dishwasher favorit 65070 vi
AEG FAVORIT 65070 Vi에 대해서도 마찬가지입니다: 사용자 정보 (40 페이지)

페이지 인쇄

Connecting the dishwasher

Connecting to the water supply

• The dishwasher can be connected to cold and hot water supplies up

to max. 60°C.

• The dishwasher must not be connected to open hot water appliances

or instantaneous water heaters.

Permitted water pressure

Lowest permitted water pressure:

1 bar (=10 N/cm2 =100 kPa)

Highest permitted water pressure:

10 bar (=100 N/cm2 =1 MPa)

Connecting the inlet hose

The water inlet hose must not be kinked, crushed or entangled when it

is being connected.

Connect the threaded hose fitting (ISO 228-1:2000) on the water inlet

hose to a tap with an external thread (¾ inch). The inlet hose is fitted

with either a plastic or a metal nut:

– Only tighten the nut hand tight.

Then do a visual check for water tightness. (Make sure that the tap is

not dripping.)

So that access to the tap in the kitchen is not restricted by the use of

the dishwasher, we recommend installing an additional tap, or fitting a

T-branch to the existing tap.

If you need a longer water inlet hose than that supplied, the following

VDE-approved complete hose sets are to be used. These are available

from your local service centre.

Consult your plumber if the water pres-

sure is less than 1 bar.

If the water pressure is greater than 10

bar, a pressure reduction valve must be

used (available from your dealer).