Brother DCP-7020 설정 매뉴얼 - 페이지 8
{카테고리_이름} Brother DCP-7020에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother DCP-7020 23 페이지. Windows vista
Brother DCP-7020에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (31 페이지), 부품 참조 목록 (30 페이지)
페이지 인쇄
STEP 2
Installing the Driver & Software
How to connect the machine to your computer
For DCP-130C, MFC-240C, MFC-440CN,
MFC-5460CN and MFC-5860CN users
(The illustrations are based on MFC-5460CN.)
1
Lift the scanner cover until it locks securely into
the open position.
2
Connect the USB cable to the USB socket
marked with a
USB socket inside the machine on the right as
shown below.
3
Carefully guide the USB cable into the trench
as shown below, following the trench around
and toward the back of the machine. Then,
connect the cable to your computer.
6
symbol. You will find the
Improper Setup
• DO NOT connect the machine to a USB port on
a keyboard or a non-powered USB hub.
Brother recommends that you connect the
machine directly to your computer.
• Make sure that the cable does not restrict the
cover from closing, or an error may occur.
• Make sure you use a USB 2.0 cable that is no
longer than 6 feet long (2 meters).
4
Lift the scanner cover to release the lock ( ).
Gently push the scanner cover support
down ( ) and close the scanner cover ( ).
5
Turn on the machine by connecting the power
cord.
The installation of the Brother drivers will
automatically start. The installation screens
appear one after another. Please wait, it will
take a few seconds for all the screens to
appear.
Improper Setup
DO NOT try to cancel any of the screens during
this installation.
®
Windows