A-Fire Design AW-VIP 사용자 설명서 - 페이지 5

{카테고리_이름} A-Fire Design AW-VIP에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. A-Fire Design AW-VIP 11 페이지.

Device equipped with exterior connection (dry contact) to allow for remote operation with a distant

switch or by a smart-home installation. Never start or use a device without supervision.

Device equipped with a Wi-Fi application for smartphones.

3. PRECAUTIONS FOR INSTALLING THE DEVICE IN ITS ENVIRONMENT:

Do not play any object on the device while operating. Leave access to the control components free.

Do not use in a room with air currents.

4. ELECTRIC CONNECTION TO YOUR DEVICE

Your device is sent with INPUT electric power of 100-240 volts (50/60 Hz) and OUTPUT of 24 volts.

Before embedding your device, you must connect the electric power to a 100-240 volt/50/60 Hz – 12-

amp circuit.

If you want to an external connection for a remote switch control or smart-home installation, you must

use the dry contact meant for this purpose.

5. Installation diagrams:

AFIRE devices are meant to be embedded without needing any ventilation in the housing for the

device.

In the housing, you must install a normal 110/240 volt (12 amp) electric current in order to power the

device through a 24-volt transformer.

You must also install water supply if you want to connect your device directly.

See the daagram below for the embedding dimensions.

You must leave 5 cm minimum around the device to facilitate installation.