Fujitsu AB G36LRTE Series 디자인 및 기술 매뉴얼 - 페이지 29

{카테고리_이름} Fujitsu AB G36LRTE Series에 대한 디자인 및 기술 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu AB G36LRTE Series 47 페이지. Ceiling type
Fujitsu AB G36LRTE Series에 대해서도 마찬가지입니다: 디자인 및 기술 매뉴얼 (47 페이지)

페이지 인쇄
Fujitsu AB G36LRTE Series 디자인 및 기술 매뉴얼
CONTENTS OF FUNCTION SETTING
•
Follow the instructions in the Local Setup Procedure, which is supplied with the remote control, in
accordance with the installed condition.
After the power is turned on, perform the Function Setting on the remote control.
•
The settings may be selected between the following two: Function Number or Setting Value.
•
Settings will not be changed if invalid numbers or setting values are selected.
1)
2)
3)
Cooler room temperature correction
4)
Heater room temperature correction
5)
6)
Indoor room temperature sensor switching function
7)
8)
9)
Indoor unit fan control for energy saving
1) Filter sign
The indoor unit has a sign to inform the user that it is time to clean the filter. Select the time setting
for the filter sign display interval in the table below according to the amount of dust or debris in the
room. If you do not wish the filter sign to be displayed, select the setting value for "No indication".
Setting Description
"Standard
(2,500 hours)"
"Long interval
(4,400 hours)"
"Short interval
(1,250 hours)"
No indication
2) Ceiling height
Select the setting values in the table below according to the height of the ceiling.
Setting Description
Standard
(2.5m to 3.0m)
High ceiling
(3.0m or more)
3) Cooler room temperature correction
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be selected as shown in the table below.
Setting Description
Standard
Slightly Lower control
Lower control
Warmer control
4) Heater room temperature correction
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be changed as shown in the table below.
Setting Description
Standard
Lower control
Slightly warmer control
Warmer control
Filter sign
Ceiling height
Auto restart
Remote controller signal code
External input control
Function Number
11
Function Number
20
Function Number
30
Function Number
31
- (01 - 26) -
( . . .Factory setting)
Setting Value
00
01
02
03
( . . .Factory setting)
Setting Value
00
01
( . . .Factory setting)
Setting Value
00
01
02
03
( . . .Factory setting)
Setting Value
00
01
02
03