Fujitsu ABT18LBAJ 운영 매뉴얼 - 페이지 5

{카테고리_이름} Fujitsu ABT18LBAJ에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ABT18LBAJ 18 페이지. Floor console/under ceiling dual type

페이지 인쇄

Fig. 1 Indoor Unit

1 Operating Control Panel (Fig. 2)

2 MANUAL AUTO button

3 Remote Control Signal Receiver

4 OPERATION Indicator Lamp (red)

5 TIMER Indicator Lamp (green)

6 SWING Indicator Lamp (orange)

(VERTICAL SWING)

7 SWING Indicator Lamp (orange)

(HORIZONTAL SWING)

●

If the TIMER indicator lamp flashes when

the timer is operating, it indicates that a

fault has occurred with the timer setting

(See page 16 Auto Restart).

8 Intake Grille (Fig. 3)

9 Air Filter

0 UP/DOWN Air Direction Flaps

A RIGHT/LEFT Air Direction Louvers

(behind UP/DOWN Air Direction Flaps)

B Drain Hose

Fig. 4 Remote Control Unit

C SLEEP button

D MASTER CONTROL button

E SET TEMP./SET TIME buttons (

F Signal Transmitter

G TIMER button

H FAN CONTROL button

I START/STOP button

J AIR FLOW DIRECTION

VERTICAL SET button

K AIR FLOW DIRECTION

VERTICAL SWING button

L AIR FLOW DIRECTION

HORIZONTAL SET button

M AIR FLOW DIRECTION

HORIZONTAL SWING button

N TIME ADJUST button

O ACL button

Rear side (Fig. 5)

P TEST RUN

● Touch the two metal contacts with a me-

tallic object to send the signal to perform

a test run.

● Perform a test run only when installing the

air conditioner. If the signal to perform a

test run is received during normal opera-

tion, the air conditioner's thermostat will

malfunction.

● If the signal to perform a test run is re-

ceived during normal operation, the unit

will switch to the test operation mode and

the indoor unit's OPERATION and TIMER

indicator lamps will flash simultaneously.

● To stop the test operation mode, press the

START/STOP button to stop the air condi-

tioner.

Q Remote Control Unit Display (Fig. 6)

R Transmit Indicator

S Clock Display

T Operating Mode Display

U T imer Mode Display

V Fan Speed Display

W Temperature Set Display

X T imer Set Indicator

Y Temperature Set Indicator

)