Fujitsu ABT24RG 운영 매뉴얼 - 페이지 13
{카테고리_이름} Fujitsu ABT24RG에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ABT24RG 17 페이지. Floor console/under ceiling dual type
Fujitsu ABT24RG에 대해서도 마찬가지입니다: 운영 매뉴얼 (17 페이지), 운영 매뉴얼 (17 페이지)
페이지 인쇄
ENERGY SAVE OPERATION
Instructions relating to heating (*) are applicable only to "HEAT & COOL MODEL" (Reverse Cycle).
The air conditioner can be operated while keeping energy consumption costs down.
How To Use the ENERGY SAVE OPERATION
1
Press the START/STOP button
(if the unit is already operating, proceed to step 2).
The indoor unit's OPERATION indicator lamp (red) will light.
2
Press the MASTER CONTROL button to select the
COOL, DRY, *HEAT mode.
3
Press the ENERGY SAVE button.
ENERGY SAVE can only be used if the MASTER CONTROL button is used
to select the "COOL", "DRY" or *"HEAT".
About the ENERGY SAVE
The air conditioner saves energy costs by controlling the thermostat temperature setting.
*During Heating operation:
The thermostat temperature setting decreases by 1 °C as
soon as the ENERGY SAVE button is pressed, and then de-
creases by another 1 °C every thirty minutes.
Afterwards, energy consumption is saved by continuing to
heat at a thermostat temperature of 4 °C less than that set.
ENERGY SAVE setting
1 °C
2 °C
ENERGY
30 minutes
SAVE ON
1 hour
1 hour 30 minutes
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the remote control unit is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button on the main unit control
panel.
To stop operation, press the MANUAL AUTO button once again.
Set
temperature
3 °C
4 °C
To Cancel the ENERGY SAVE:
Press the ENERGY SAVE button.
During Cooling/Dry operation:
The thermostat temperature setting increases by 1 °C as soon
as the ENERGY SAVE button is pressed, and then increases
by another 1 °C after one hour has passed.
Afterwards, energy consumption is saved by continuing to
cool or dry at a thermostat temperature of 2 °C more than
that set.
ENERGY SAVE setting
1 hour
ENERGY
SAVE ON
1 °C
G When the air conditioner is operated
with the controls on the Main unit, it
will operate under the same mode as
the AUTO mode selected on the re-
mote control unit (see page 8).
G The fan speed selected will be "AUTO"
and the thermostat setting will be
23 °C.
SET
SWING
SET
SWING
TIME
TEST
ENERGY
ADJUST
RUN ACL
SAVE
2 °C
Set
temperature
13