Fujitsu ABU36 운영 매뉴얼 - 페이지 5

{카테고리_이름} Fujitsu ABU36에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu ABU36 18 페이지. Ceiling type (60 hz)
Fujitsu ABU36에 대해서도 마찬가지입니다: 서비스 매뉴얼 (20 페이지)

페이지 인쇄

Fig. 1 Indoor Unit

1 Operating Control Panel (Fig. 2)

2 MANUAL AUTO button

3 Remote Control Signal Receiver

4 OPERATION Indicator Light (red)

5 TIMER Indicator Light (green)

6 SWING Indicator Light (orange)

(HORIZONTAL SWING)

7 SWING Indicator Light (orange)

(VERTICAL SWING)

If the TIMER indicator light flashes when

the timer is operating, it indicates that a

fault has occurred with the timer setting

(See Page 17 Auto Restart).

8 Intake Grille

9 UP/DOWN Air Direction Flap

0 RIGHT/LEFT Air Direction Louvers

(behind UP/DOWN Air Direction Flap)

Fig. 4 Outdoor Unit

A Intake side

B Outlet side

Fig. 5 Remote Control Unit

C SLEEP Button

D MASTER CONTROL Button

E SET TEMP./SET TIME Buttons (

F Signal Transmitter

G TIMER Button

H FAN CONTROL Button

I START/STOP Button

J Battery compartment lid

Inside of the battery compartment lid (Fig. 6)

K AIR FLOW DIRECTION Button

L ENERGY SAVE Button

M CODE CHANGE (Slide Switch)

Switching the remote control unit code.

(Max. 4 units)

N TIME ADJUST Button

O TEST RUN Button

This button is used when installing the air

conditioner and should not be used under

normal conditions as it will cause the air

conditioner's thermostat function to oper-

ate incorrectly.

If this button is pressed during normal op-

eration, the unit will switch to test opera-

tion mode, and the indoor unit's OPERA-

TION indicator light and TIMER indicator

light will begin to flash simultaneously.

To stop the test operation mode, either

press the TEST RUN button once again, or

press the START/STOP button to stop the

air conditioner.

P ACL Button

Q Remote Control Unit Display (Fig. 7)

R Transmit Indicator

S Clock Display

T Operating Mode Display

U Timer Mode Display

V Fan Speed Display

W Temperature Set Display

X Timer Set Indicator

Y Temperature Set Indicator

)

En-5