Fujitsu AGTG09KVCA 운영 매뉴얼 - 페이지 11
{카테고리_이름} Fujitsu AGTG09KVCA에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fujitsu AGTG09KVCA 16 페이지.
페이지 인쇄4. Reinstall the air filter.
Align the sides of the air filter with the panel, and push in fully,
making sure the 2 upper tabs are returned properly to their holes in
the panel.
Air filter
Panel
5. Close the intake grille.
NOTES: If dirt accumulates on the air filter, airflow will be reduced,
operating efficiency will lower, and the noise will increase.
Cleaning Ion deodorization filter and
Replacing Apple-catechin filter
1. Remove the air filter. Refer to steps 1 ~ 2 of "Cleaning air
filter".
2. Remove the air
cleaning filters from
the indoor unit.
3. Flush the Ion deodorization filter (light blue) with high
pressure hot water until the surface of the filters are covered
with water.
4. Wash the Ion deodorization filter with diluent neutral
detergent.
Do not ream or rub, otherwise the deodorizing effect may decrease.
5. Rinse the Ion deodorization filter with water flow.
6. Dry the Ion deodorization filter in shade.
7. Remove the Apple-catechin filter (light green) from the
indoor unit.
8. Set the new or washed air cleaning filters into the indoor
Air filter
Panel
NOTES: Use the Apple-catechin filter as soon as possible after opening
9. Reinstall the air filter and close the intake grille. Refer to
1. Remove the air filters. Refer to steps 1 ~ 2 of "Cleaning air
2. Remove the Ion deodorization filter (light blue) from the
3. Install the new Ion deodorizing filter.
If you have shut down the indoor unit for 1 month or more, perform the
Fan mode operation for half a day to dry the internal parts thoroughly
before the normal operation.
Air cleaning filters
After long period of use, accumulated dust inside the indoor unit may
reduce the performance even if you have maintained the unit properly.
In such a case, a product inspection is recommended.
For more information, consult authorized service personnel.
This function can be used if set correctly during installation. Please
consult authorized service personnel in order to use this function.
)
Indicator lamp
After cleaning, reset the filter indicator by pushing
indoor unit for 2 seconds or less.
unit.
Catch it on 5 places of picks.
(3 places of upper parts and lower part 2 places.)
the package. The air cleaning effect decreases when the filters
are left in the opened package.
steps 4 ~ 5 of "Cleaning air filter".
Replacing Ion deodorization filter
filter".
indoor unit.
After extended non-use of the unit
Additional inspection
Filter indicator reset (Special setting)
Clean the air filter when the indicator lamp show the
following:
Blinks 3 times, at intervals of 21 seconds
Air cleaning filters
Blinking pattern
on the
En-10