AEG FSS62700P 사용자 설명서 - 페이지 21

{카테고리_이름} AEG FSS62700P에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG FSS62700P 24 페이지.

페이지 인쇄

Refer to "Before first use",

"Daily use", or "Hints and

tips" for other possible

causes.

Once you have checked the appliance,

deactivate and activate the appliance. If

12.1 The washing and drying results are not satisfactory

Problem

Poor washing results.

Poor drying results.

There are whitish streaks or

bluish layers on glasses and

dishes.

There are stains and dry water

drops on glasses and dishes.

The dishes are wet.

The interior of the appliance is

wet.

Unusual foam during washing. • Use the detergent for dishwashers only.

the problem occurs again, contact an

Authorised Service Centre.

For alarm codes not described in the

table, contact an Authorised Service

Centre.

Possible cause and solution

• Refer to "Daily use", "Hints and tips" and basket

loading leaflet.

• Use more intensive washing programmes.

• Clean spray arm jets and filter. Refer to "Care and

Cleaning".

• Tableware has been left for too long inside a closed

appliance.

• There is no rinse aid or the dosage of rinse aid is not

enough. Set the rinse aid dispenser to a higher level.

• Plastic items may need to be towel dried.

• For the best drying performance activate the option

XtraDry and set AirDry.

• We recommend to always use rinse aid, even in com-

bination with multi-tablets.

• The release quantity of rinse aid is too much. Adjust

the rinse aid level to a lower level.

• The quantity of detergent is too much.

• The released quantity of rinse aid is not sufficient. Ad-

just the rinse aid level to a higher level.

• The quality of the rinse aid can be the cause.

• For the best drying performance activate the option

XtraDry and set AirDry .

• The programme does not have a drying phase or has

a drying phase with low temperature.

• The rinse aid dispenser is empty.

• The quality of the rinse aid can be the cause.

• The quality of the multi-tablets can be the cause. Try a

different brand or activate the rinse aid dispenser and

use rinse aid and multi-tablets together.

• This is not a defect of the appliance. it is caused by

the humidity in the air that condenses on the walls.

• There is a leak in the rinse aid dispenser. Contact an

Authorised Service Centre.

ENGLISH