AEG OKO FAVORIT 40660 i 사용자 지침 - 페이지 26

{카테고리_이름} AEG OKO FAVORIT 40660 i에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG OKO FAVORIT 40660 i 44 페이지. Aeg dishwasher
AEG OKO FAVORIT 40660 i에 대해서도 마찬가지입니다: 사용자 정보 (44 페이지), 사용자 지침 (40 페이지), 사용자 지침 (44 페이지), 사용자 지침 (48 페이지)

페이지 인쇄

Operating Instructions

Start the Wash Programme

1. Check that when the dishes and cutlery are loaded into the dishwasher

the spray arms are free to rotate.

2. Open the tap fully.

3. Shut the door.

4. Press the ON/OFF button. The ON/OFF button indicator illuminates.

5. Press the programme button for the desired programme (see "Pro-

gramme Table"). The programme indicator illuminates. The selected

programme begins after around 6 seconds. The time remaining until

the end of the programme is displayed on the multi-display, the time

calculated is dependent on the load in the baskets.

With automatic programme adjustment this residual time count can be

stopped or corrected if necessary (load quantity, degree of dirtiness,

etc.) using the dishwasher control.

If fault messages are displayed on the multi-display after the start of

the programme, please read the "What to do, if..." section.

Changing/Interrupting/Cancelling

the Wash Programme

Only change or interrupt a wash programme in progress if it is abso-

lutely necessary to do so.

Changing the wash programme

If you want to change the wash programme within 6 seconds of mak-

ing a programme selection, briefly press the button for the new wash

programme.

If you want to change the wash programme at a later point in time, use

the following procedure:

1. Press the button for the new wash programme and hold it pressed. The

indicators for both programmes now flash.

2. After a few seconds only the indicator for the new programme flashes.

Release the programme button, the new programme is now running.

Interrupting the wash programme by opening the door of the

dishwasher

Hot steam may escape from the appliance when opening the door.

Open the door carefully.