AEG OKO-FAVORIT 55750 사용 설명서 지침 - 페이지 23
{카테고리_이름} AEG OKO-FAVORIT 55750에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG OKO-FAVORIT 55750 32 페이지. Aeg dishwasher
AEG OKO-FAVORIT 55750에 대해서도 마찬가지입니다: 사용 설명서 지침 (29 페이지)
페이지 인쇄
Remedying faults
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out
an engineer. Before contacting your local Service Force Centre, please carryout the checks listed below.
Important:
If you call out an engineer to a fault listed below or to repair a fault caused by incorrect use or
installation a charge will be made even if the appliance is in guarantee.
The drain pump runs continually even when the ap−
pliance is switched off.
− The water protection system has been triggered.
First close the water taps, and then pull out the
mains plug or switch off or turn out the fuses. Call
AEG Service Force.
The program does not start.
− Are the fuses of the fixed installation in order? Is the
appliance connected to the electrical supply?
− Has the door been properly closed? Press the door
shut until the door lock latches in.
− Has the pre−select start time been set?
The machine does not fill with water.
− Is the water tap completely open?
− Is the water tap blocked? Open and close the water
tap several times.
− Is the strainer in the hose fitting to the water tap
blocked? Clean the strainer if necessary.
− Is the inlet hose kinked? Check the hose run.
− Is a minimum water flow pressure of 1 bar availa−
ble?
The program sequence display remains static at the
start of the cleaning
− Is the water tap completely open?
− Is the strainer in the hose fitting at the water tap
blocked? Clean if necessary.
The water is not pumped away
− Is the drain hose kinked? Check the run of the hose
(see the "Water Drainage" section).
− Is the sink drain blocked? Clear any blockages.
The crockery is not clean
− Have you selected a program that is suitable for the
type and degree of soiling of your crockery? (see
Program Chart)
− Have you arranged the crockery so that the sprayed
water has access to all surfaces, both internal and
external? The crockery baskets must not be overfil−
led.
− Was the spray arm blocked by crockery or pieces of
cutlery?
− Are the spray arm nozzles clean?
− Are all the filters in the base of your dishwasher
clean? Have the filters been installed correctly?
− Have you used the correct amount of detergent?
− Is the drain hose correctly filted.
− Is the on−site sink drain blocked?
− Is there salt in the salt dispenser? Without it, the
water will not be softened. Lime deposits can form
on your crockery and in the machine.
− Has the water softener system been set to the local
water hardness?
The crockery is not dry, and has no sparkle.
− Is there rinse aid in the dispenser?
− Has the salt dosage been correctly set?
Glasses and dishes have streaks, stripes, milky blot−
ches or blue−coloured bloom.
− The rinse aid is being overdosed. Set a lower rinse
aid dosage
Glasses and dishes have dried−on "water drops".
− The rinse aid is being underdosed. Set the rinse aid
dosage higher.
− Is the lid of the salt container properly closed?
Rust marks can be seen in the washing area.
− The dishwasher interior is made of stainless steel.
Rust marks inside the dishwasher are caused by ex−
ternal rust (rust particles from the water piping,
from pans, cutlery etc.). Remove such marks using
a commercially−available stainless steel cleaner.
− Was the "Pre−rinse" program started immediately
after refilling the salt?
23