Brother MFC-J491DW 참조 매뉴얼 - 페이지 12

{카테고리_이름} Brother MFC-J491DW에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother MFC-J491DW 26 페이지. Brief explanations for routine operations
Brother MFC-J491DW에 대해서도 마찬가지입니다: 참조 매뉴얼 (34 페이지), 빠른 설정 매뉴얼 (2 페이지), 빠른 설정 매뉴얼 (2 페이지), 참조 매뉴얼 (32 페이지), 매뉴얼 (19 페이지), 매뉴얼 (22 페이지), 빠른 설정 매뉴얼 (2 페이지), 빠른 설정 매뉴얼 (2 페이지), 제품 안전 매뉴얼 (21 페이지)

페이지 인쇄
Brother MFC-J491DW 참조 매뉴얼
6
Fax

Before Faxing

Telephone Line Interference/

VoIP
If you are having problems sending or
receiving a fax due to possible interference on
the telephone line or if you are using a VoIP
system, we recommend changing the modem
speed to minimize errors in fax operations.
1
Press Settings.
2
Press a or b to select the following:
a. Select [Initial Setup].
Press OK.
b. Select [Compatibility].
Press OK.
c. Select [Normal] or [Basic(for
VoIP)]. Press OK.
• [Basic(for VoIP)] reduces
the modem speed to 9,600 bps
and turns off color fax receiving
and Error Correction Mode
(ECM), except for color fax-
sending. Unless interference is a
recurring problem on your
telephone line, you may prefer to
use it only when needed.
To improve compatibility with
most VoIP services, Brother
recommends changing the
compatibility setting to
[Basic(for VoIP)].
• [Normal] sets the modem
speed at 14,400 bps.
3
Press Stop/Exit.
• VoIP (Voice over IP) is a type of phone
system that uses an Internet
connection, rather than a traditional
phone line.

Send a Fax

1
Load your document in the ADF or place
it on the scanner glass.
2
Press
(FAX).
The LCD displays:
Press Start
Enter Number
Fax Resolution
Standard
Contrast
3
Enter the fax number in one of the
following ways:
• Dial Pad (Enter the fax number
manually.)
Press all digits of the number using
the dial pad.
• Redial (Redial the last number you
dialed.)
Press Redial/Pause.
• Outgoing call (Select a number from
the Outgoing Call history.)
Press a or b to select the following:
a. Select [Call History].
Press OK.
b. Select [Outgoing Call].
Press OK.
c. Select the number you want, and
then press OK.
d. Press c to select [Apply].
Auto
11