Brother MFC-J5730DW 참조 매뉴얼 - 페이지 23

{카테고리_이름} Brother MFC-J5730DW에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother MFC-J5730DW 32 페이지.
Brother MFC-J5730DW에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (2 페이지)

페이지 인쇄

Error Message

Data Remaining in

Memory

Disconnected

Document Jam/too

Long

High Temperature

Hub is Unusable.

Ink Absorber

NearFull

Ink Absorber Pad

Full

Ink Low

Install Ink

Action

Press

. The machine will cancel the job and clear it from the

memory. Try to print again.

Try to send or receive again.

If calls are stopped repeatedly and you are using a VoIP (Voice over

IP) system, try changing the Compatibility to Basic (for VoIP).

See Related Information: Telephone Line Interference/VoIP at the end

of this section.

The document was not inserted or fed correctly, or the document

scanned from the ADF was too long.

For more information, see the Online User's Guide: Document Jams.

After cooling the room, allow the machine to cool down to room

temperature. Try again when the machine has cooled down.

Hubs, including a USB flash drive with a built-in hub, are not

supported. Unplug the device from the USB direct interface.

The ink absorber box or flushing box must be replaced soon. Contact

Brother customer service or your local Brother dealer.

The ink absorber box or flushing box must be replaced. Contact

Brother customer service or your local Brother Authorised Service

Centre to have your machine serviced.

Reasons for cleaning are:

1. The machine automatically cleans itself after you remove the

power cord and plug it back in.

2. After a paper jam has been cleared, the machine automatically

cleans itself before the next received page is printed.

3. The machine automatically cleans itself after sitting idle for more

than 30 days (infrequent use).

4. The machine automatically cleans itself after ink cartridges of the

same colour have been replaced 12 times.

One or more of the ink cartridges are near the end of their lives.

Order a new ink cartridge. You can continue printing until the

Touchscreen displays Replace Ink.

For more information, see the Online User's Guide: Replace the Ink

Cartridges.

• You can still scan even if the ink is low or needs to be

replaced.

Remove the new ink cartridge and re-install it slowly and firmly until it

locks into place.

For more information, see the Online User's Guide: Replace the Ink

Cartridges.