AEG 34942G 작동 및 설치 지침 - 페이지 25

{카테고리_이름} AEG 34942G에 대한 작동 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 34942G 26 페이지. Gas hobs
AEG 34942G에 대해서도 마찬가지입니다: 운영 및 설치 매뉴얼 (26 페이지), 작동 및 설치 지침 (26 페이지), 작동 및 설치 지침 (26 페이지), 작동 및 설치 지침 (27 페이지)

Commissioning

When the hob has been fully installed it will be necessary to check the

minimum flame setting. To do this, follow the procedure below.

1) Turn the gas tap to the MAX position and ignite.

2) Set the gas tap to the MIN flame position then turn the control

knob from MIN to MAX several times. If the flame is unstable or is

extinguished follow the procedure below.

Procedure:

1) Re-ignite the burner and set to

MIN.

2) Remove the control knob.

3) The adjustment screw is located

down the centre of the gas tap

control shaft.

To adjust, use a thin bladed

screwdriver and turn the

adjustment screw until the flame

is steady and does not extinguish,

when the knob is turned from

MIN to MAX. Repeat this

procedure for all burners.

1) Remove left hand pan support and front left burner cap and crown.

2) Fit manometer tube over the injector.

3) Turn on the burner gas supply and ignite another burner supply.

The pressure reading should be nominally 20mbar and must be

between 17 mbar and 25mbar.

4) Turn off the burner supplies.

FO 1042

a) Minimum adjustment screw

b) Tap