Brother MFC-J6959DW 빠른 설정 매뉴얼

{카테고리_이름} Brother MFC-J6959DW에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother MFC-J6959DW 2 페이지.

Quick Setup Guide

MFC-J6959DW

Read the Product Safety Guide ﬁrst, then read this Quick Setup Guide for the correct installation procedure.

Unpack the machine and check the components

Remove the protective tape or film covering the machine and the supplies. The components included in the box may differ depending on your country.

• The images in this guide are for illustration purposes only and may differ from the

actual products.

Load plain A4 paper in Tray #1

Pull Tray #1 completely out of

the machine as shown by the

arrow.

Connect the power cord

Install the inbox ink cartridges

Open the ink cartridge cover.

Check the print quality

Follow the LCD instructions,

Follow the LCD instructions and

and then press [Start].

check the quality of the four

The machine prints the Print

colour blocks on the sheet, and

Quality Check Sheet.

then start the cleaning procedure

if required.

Video setup instructions:

support.brother.com/videos

Fan the paper well.

Load the paper in the tray

and adjust the paper guides.

NOTE

You can adjust the control panel

angle to read the LCD more easily.

Quickly shake just the black

ink cartridge horizontally

15 times as shown, before

inserting it into the machine.

Poor

Follow the LCD instructions

to print the Adjustment

Sheet. The black circle mark

is located in the upper right

corner of the sheet.

The latest manuals are available at the Brother support website:

support.brother.com/manuals

NOTE

• Save all packing materials and the box in case you must ship your machine.

• You must purchase the correct interface cable for the interface you want to use.

USB cable

Use a USB 2.0 cable (Type A/B) that is no more than 5 metres long.

Ethernet (Network) cable

Use a straight-through Category 5 (or greater) twisted-pair cable for 10BASE-T or

100BASE-TX Fast Ethernet Network.

• Brother aims to reduce waste and save both raw materials and the energy required to

produce them. Read more about our environmental work at www.brotherearth.com.

After finishing the machine setup, you can change the paper type or size. For more information

about paper handling, see the Online User's Guide at support.brother.com/manuals.

Do not exceed

this mark (bbb).

Slowly push Tray #1

completely into the machine.

Select your country or language

After turning the machine on, you may need to set your country or language (depending on

your machine). If required, follow the LCD instructions.

Follow the LCD instructions to

install the ink cartridges. Close the

ink cartridge cover. The machine

will prepare the ink tube system for

printing.

NOTE

The first time you install a set of ink

cartridges the machine will use an

amount of ink to fill the ink delivery

tubes for high quality printouts. This

process will only happen once.

Adjust the print alignment (recommended)

To adjust the print alignment before using your machine, press [Start].

Place the Adjustment Sheet

face down on the scanner

glass. Make sure the black

circle is in the upper left corner

of the scanner glass.

D028LH001-00

Version 0

Pull out the paper support until

it locks into place.

Set the date and time

Follow the LCD instructions to set the date

and time.

After setting the date and time, you can set

the Brother LCD message defaults.

Follow the LCD instructions

and complete adjusting the

alignment.

When finished, remove the

Adjustment Sheet from the

scanner glass.