Brother MFC-J895DW 매뉴얼 - 페이지 14

{카테고리_이름} Brother MFC-J895DW에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother MFC-J895DW 22 페이지. Brief explanations for routine operations
Brother MFC-J895DW에 대해서도 마찬가지입니다: 참조 매뉴얼 (28 페이지), 매뉴얼 (19 페이지), 빠른 설정 매뉴얼 (2 페이지)

페이지 인쇄

For protection against the risk of electrical shock, always disconnect all cables from the wall

outlet before the equipment is installed, serviced, or modified.

IMPORTANT

• This product has been certified to comply with FCC standards, which are applied to the USA

only.

• This equipment may not be used on coin service lines provided by the telephone company

or connected to party lines.

• Brother cannot accept any financial or other responsibilities that may be the result of your

use of this information, including direct, special, or consequential damages. There are no

warranties extended or granted by this document.

• A grounded plug should be plugged into a grounded AC power outlet after checking the

rating of the local power supply for the product to operate properly and safely.

Standard Telephone and FCC Notices (MFC Models Only)

These notices are in effect on models sold and used in the United States only.

When programming emergency numbers or making test calls to emergency numbers:

• Remain on the line and briefly explain to the dispatcher the reason for the call before

hanging up.

• Perform these activities in the off-peak hours, such as early morning or late evening.

This equipment complies with Part 68 of the FCC rules and the requirements adopted by the

ACTA. On the back side of this equipment is a label that contains, among other information, a

product identifier in the format US: AAAEQ##TXXXX. If requested, this number must be

provided to the telephone company.

You may safely connect this equipment to the telephone line by means of a standard modular

jack, USOC RJ11C.

A plug and jack used to connect this equipment to the premises wiring and telephone network

must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A

compliant telephone cord and modular plug is provided with this product. It is designed to be

connected to a compatible modular jack that is also compliant. See installation instructions for

details.

The Ringer Equivalence Number (REN) is used to determine the number of devices that may be

connected to a telephone line. Excessive RENs on a telephone line may result in the devices

not ringing in response to an incoming call. In most but not all areas, the sum of RENs should

not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as

determined by the total RENs, contact the local telephone company. For products approved

after July 23, 2001, the REN for this product is part of the product identifier that has the format