Brother Work Smart MFC-J870dw 빠른 시작 매뉴얼 - 페이지 23
{카테고리_이름} Brother Work Smart MFC-J870dw에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother Work Smart MFC-J870dw 45 페이지. Work smart series inkjet all-in-one
Brother Work Smart MFC-J870dw에 대해서도 마찬가지입니다: 에어 프린트 매뉴얼 (12 페이지), 사양 (2 페이지), 기본 사용 설명서 (14 페이지)
페이지 인쇄
Wired Network
For Macintosh wired network interface users (MFC-J870DW only)
(Mac OS X v10.6.8, 10.7.x, 10.8.x)
14
Before you install
Make sure your machine is connected to the power
and your Macintosh is ON. You must be logged on
with Administrator rights.
NOTE
• For Mac OS X v10.6.0 to 10.6.7 users, upgrade
to Mac OS X v10.6.8 - 10.8.x.
• If you have previously set up your machine for
a wireless network and then want to set it up on
a wired network, make sure the machine's
Network I/F is set to Wired LAN. The
wireless network interface will become inactive
with this setting.
On your machine, press
Press All Settings.
Press a or b to display Network.
Press Network.
Press a or b to display Network I/F.
Press Network I/F.
Press Wired LAN.
Press
.
15
Connect the network
cable
a
Lift the scanner cover until it locks securely into
the open position.
(Settings).
b
Connect the network cable to the Ethernet port
marked with a
Ethernet port inside the machine, as shown in
the callout below. Remove the protective
cap b before connecting the cable.
1
2
c
Carefully guide the network cable into the cable
channel and out the back of the machine.
Connect the cable to your network.
IMPORTANT
Make sure that the cable does not restrict the
cover from closing, or an error may occur.
NOTE
• If both the USB and the network cables are
being used, guide both cables through the
cable channel with one on top of the other.
• If you have connected a telephone line, make
sure it is placed it into the cable channel first.
Press down gently on each additional cable as
you guide it through the channel.
Macintosh
symbol a. You will find the
23