AEG 6530 DG-M 지침 및 설치 안내서 - 페이지 16

{카테고리_이름} AEG 6530 DG-M에 대한 지침 및 설치 안내서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 6530 DG-M 25 페이지. Electrolux user information gas hob
AEG 6530 DG-M에 대해서도 마찬가지입니다: 지침 및 설치 안내서 (12 페이지)

페이지 인쇄
AEG 6530 DG-M 지침 및 설치 안내서
It is not necessary to attach the
reinforcement beam to the table
surface, as it is held in place by a
specially designed moulding, which is
incorporated in the hob units flanges.
Installation in work tops with a
base unit underneath
If the hob is to be installed on top of a
base unit, a board must be mounted
underneath the hob (e.g. 16 mm chip
board).
Seal all joints with aluminium tape.
The board can be mounted as shown in
the diagram.
This installation method prevents the
flames from being extinguished if you
close the door of the base unit hard.
If the back panel of the cupboard unit
is of thin 4 mm material, it will need to
be reinforced.
This procedure will prevent the gas
being blown out if the cupboard door
is slammed shut.
Min. 140 mm
Min. 16 mm
Aluminium-tape
Min. 140 mm
Min. 16 mm
Aluminium-tape