AEG 66301K-mn 설치 및 운영 지침 매뉴얼 - 페이지 34

{카테고리_이름} AEG 66301K-mn에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 66301K-mn 40 페이지. Ceramic glass hob
AEG 66301K-mn에 대해서도 마찬가지입니다: 사용자 설명서 (29 페이지)

페이지 인쇄

Safety Instructions for the Installer

• A device must be provided in the electrical installation which allows

the appliance to be disconnected from the mains at all poles with a

contact opening width of at least 3 mm.

Suitable isolation devices include line protecting cut-outs, fuses

(screw type fuses are to be removed from the holder), earth leakage

trips and contactors.

• In respect of fire protection, this appliance corresponds to

EN 60 335-2-6. This type of appliance may be installed with a high

cupboard or wall on one side.

• Drawers may not be fitted underneath the hob.

• The installation must guarantee shock protection.

• The kitchen unit in which the appliance is fitted must satisfy the sta-

bility requirements of DIN 68930.

• For protection against moisture, all cut surfaces are to be sealed with

a suitable sealant.

• On tiled work surfaces, the joints in the area where the hob sits must

be completely filled with grout.

• On natural, artificial stone, or ceramic tops, the snap action springs

must be bonded in place with a suitable artificial resin or mixed ad-

hesive.

• Ensure that the seal is correctly seated against the work surface with-

out any gaps. Additional silicon sealant must not be applied; this

would make removal more difficult when servicing.

• The hob must be pressed out from below when removed.