Brother DCP-1510 사용 설명서 - 페이지 3

{카테고리_이름} Brother DCP-1510에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother DCP-1510 7 페이지.
Brother DCP-1510에 대해서도 마찬가지입니다: 제품 안전 매뉴얼 (25 페이지), 빠른 시작 매뉴얼 (2 페이지), 자주 묻는 질문 및 문제 해결 (3 페이지)

페이지 인쇄

WARNING: You must ensure all toner is

dumped from your cartridge before refilling with

the new toner. You must do this every refill.

Important - mixing new and old toner will cause

print defects to occur.

Shake your bottle of

new toner

vigorously for 30

seconds BEFORE

removing the cap.

Remove the cap and

seal from the bottle

STOP: Take your time when refilling.

An original cartridge contains 30g of toner. Our bottle contains 70g – that's more than double the amount of

toner than an original cartridge.

You can add the whole bottle - but it will barely fit in the cartridge. You will need to allow the toner to

settle inside the cartridge to get the toner in.

We advise adding half a bottle and topping it up later. Add 30-35g per fill (approx half a bottle)

(Each bottle contains 70g of toner – the bottle containing the toner but without the lid - will weigh approx

105g. So if you add 30g the bottle without the lid will then weigh approx 75g)

Insert the spout into

the hole. The toner

will flow out like

water, so take care

not to spill it.

Empty in an area

that can tolerate a

toner spill i.e. your

garage.

Toner can be very

messy - empty the

old toner directly

into a large bin bag.

Fit the toner pouring

spout securely to the

bottle.

Spouts are

reusable.

With the spout

inserted – carefully

"Upend" the

cartridge and allow

the toner to slowly

pour into the

cartridge.

Do not squeeze

the bottle.

Please read instructions from start to finish

before you start your refill.