Brother DCP-1512E 사용 설명서 - 페이지 7

{카테고리_이름} Brother DCP-1512E에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother DCP-1512E 7 페이지.

Reinstall the cog we removed earlier.

With the gear set in the correct position, re-install the

gear cover plate (or the new cover plate if you bought

the reset gear) and replace the two screws as shown

opposite.

The plastic cover must sit flush and the locking

clips will be active again.

Safety information: Toner powder should be treated as a nuisance dust. Not to be used by children. Avoid

inhalation. Avoid eye & skin contact. Do not ingest. Inhalation: slight irritation of respiratory tract. Consult a

doctor. Eye contact: Dust may cause irritation by mechanical abrasion. Consult a doctor. Skin contact: wash

with soap and cold running water. Ingestion: No known hazard. Carcinogenicity: N/A, Mutagenicity: AMES test

negative.

All safety information is given to help facilitate the safe use of this product and is based on information

obtained from the manufacturer. This information is believed to be correct, but does not purport to be all

inclusive and should be used only as a guide. Zinetic makes no warranty, express or Implied as to the

accuracy or completeness of this information. It is the users responsibility to determine the suitability of this

information for the adoption of necessary safety precautions and or compliance with local laws/regulations.

Zinetic is not associated with or endorsed by any of the cartridge / printer manufacturers referred to in any of

our published works. Names of manufacturers, machines and part numbers are given as an aid to

identification only. Names of manufacturers, machines and part numbers may be trade marks of the

respective manufacturer. All Trade Marks hereby expressly acknowledged.

Please read instructions from start to finish

before you start your refill.