Brother DCP-7060D 빠른 설정 매뉴얼 - 페이지 16

{카테고리_이름} Brother DCP-7060D에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother DCP-7060D 20 페이지. Printers
Brother DCP-7060D에 대해서도 마찬가지입니다: 고급 사용자 설명서 (33 페이지), 빠른 설정 매뉴얼 (20 페이지), 고급 사용자 설명서 (24 페이지), 빠른 설정 매뉴얼 (15 페이지), 기본 사용 설명서 (5 페이지)

페이지 인쇄
Brother DCP-7060D 빠른 설정 매뉴얼

For Network Users (DCP-7065DN only)

Web Based Management

(web browser)

The Brother print server is equipped with a web server
that allows you to monitor its status or change some
of its configuration settings, using HTTP (Hyper Text
Transfer Protocol).
Note
• The default User Name is 'admin' and the
default password is 'access'. You can use a
web browser to change this password.
• We recommend Microsoft
®
Explorer
6.0 (or greater) or Firefox 3.0 (or
greater) for Windows
greater) for Macintosh. Please also make sure
that JavaScript and cookies are always enabled
in whichever browser you use. To use a web
browser, you will need to know the IP address
of the print server. The IP address of the print
server is listed on the Network Configuration
Report.
a
Open your browser.
b
Type "http://machine's IP address/" into your
browser's address bar (where "machine's IP
address" is the IP address of the printer or the
print server name).
For example http://192.168.1.2/
See Web Based Management in the Network
User's Guide.
16
®
Internet
®
and Safari 3.0 (or
Print the Network Configuration
Report
You can print the Network Configuration Report to
confirm the current network settings.
a
Turn the machine on and wait until it is in the
Ready state.
b
Press Menu.
c
Press a or b to choose 4.Machine Info.
Press OK.
d
Press a or b to choose 4.Network Config.
Press OK.
e
Press Start.
The machine will print the current network
settings.
f
Press Stop/Exit.
Restore the network settings to
factory default
To restore all network settings of the internal
Print/Scan server to factory default, please follow the
steps below.
a
Make sure the machine is not operating, then
disconnect all the cables from the machine
(except the power cord).
b
Press Menu.
c
Press a or b to choose 3.Network. Press
OK.
d
Press a or b to choose 0.Network Reset.
Press OK.
e
Press a to choose Reset.
f
Press a to choose Yes.
The machine will restart, re-connect cables
once this is complete.