Brother DCP-J132W 사용자 설명서 - 페이지 40
{카테고리_이름} Brother DCP-J132W에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother DCP-J132W 44 페이지. Dcp-j132w
Brother DCP-J132W에 대해서도 마찬가지입니다: 사용자 설명서 (48 페이지), 빠른 시작 매뉴얼 (31 페이지), 자주 묻는 질문 (2 페이지)
페이지 인쇄
Extension telephone
A telephone using the same line as your
fax but plugged into a separate wall
socket.
External telephone
A TAD (telephone answering device) or
telephone that is connected to your
machine.
F/T Ring Time
The length of time that the Brother
machine rings (when the Receive Mode
setting is Fax/Tel) to notify you to pick up
a voice call that it answered.
Fax Detect
Enables your machine to respond to CNG
tones if you interrupt a fax call by
answering it.
Fax Journal
Lists information about the last 200
incoming and outgoing faxes. TX means
Transmit. RX means Receive.
Fax tones
The signals sent by sending and receiving
fax machines while communicating
information.
Fax/Tel
You can receive faxes and telephone
calls. Do not use this mode if you are
using a telephone answering device
(TAD).
Fine resolution
Resolution is 203 196 dpi. It is used for
small print and graphs.
Greyscale
The shades of grey available for copying,
scanning and faxing photographs.
Group number
A combination of Speed Dial numbers that
are stored in a Speed Dial location for
Broadcasting.
36
Innobella™
Innobella™ is a range of genuine
consumables offered by Brother. For best
quality results, Brother recommends
Innobella™ ink and paper.
Journal Period
The pre-programmed time period
between automatically printed Fax
Journal reports. You can print the Fax
Journal report on demand without
interrupting the cycle.
LCD (Liquid Crystal Display)
The display screen on the machine that
shows interactive messages during On-
Screen Programming and shows the date
and time when the machine is idle.
Manual fax
When you lift the handset of your external
telephone you can hear the receiving fax
machine answer before you press
Mono Start or Colour Start to begin
sending the fax.
Memory Receive
Receives faxes into the machine's
memory when the machine is out of paper.
Menu mode
Programming mode for changing your
machine's settings.
OCR (optical character recognition)
(MFC model)
Nuance™ PaperPort™ 12SE or Presto!
PageManager software application
converts an image of text to text you can
edit.
Overseas Mode
Makes temporary changes to the fax
tones to accommodate noise and static on
overseas telephone lines.
Pause
Allows you to place a 3.5 second delay in
the dialling sequence while you are
dialling using the dial pad or while you are
storing Speed Dial numbers. Press
Redial/Pause key on the control panel as
many times as needed for longer pauses.