Brother DCP-J515W 빠른 설정 매뉴얼 - 페이지 22
{카테고리_이름} Brother DCP-J515W에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother DCP-J515W 35 페이지.
Brother DCP-J515W에 대해서도 마찬가지입니다: 고급 사용자 설명서 (40 페이지)
페이지 인쇄
For Wireless Network Users
Connecting the Brother machine to the wireless network
Configure the wireless
11
settings (typical Wireless
Setup in infrastructure
mode)
a
On your machine, press Menu.
Press a or b to choose Network and press
OK.
(For DCP-J715W, press a or b to choose WLAN
and press OK.)
Press a or b to choose Setup Wizard and
press OK.
When WLAN Enable? or Network I/F
switched to Wireless. is displayed,
press OK to accept.
This will start the wireless setup wizard.
To cancel, press Stop/Exit.
b
The machine will search for available SSIDs. If
a list of SSIDs is displayed, use the a or b keys
to choose the SSID you wrote down in
step 10-a on page 21, then press OK. If you
are using an authentication and encryption
method that requires a Password (Network
Key), go to c.
If your authentication method is Open System
and your encryption mode is None, go to d.
Note
It will take several seconds to display a list of
available SSIDs.
If a list of SSIDs is not displayed, make sure your
access point is on. Move your machine closer to
the access point and try starting from a again.
If your access point is set to not broadcast the
SSID, you will have to manually add the SSID
name. For details, see the Network User's
Guide on the documentation CD-ROM.
c
Enter the Password (Network Key) you wrote
down in step 10-a on page 21. Press a, b, d or
c to select a letter or number, and press OK.
(For more information, see Entering Text for
Wireless Settings on page 33.)
When you have entered all the characters,
press a, b, d or c to select
OK. Then press
settings.
22
and press
OK
OK
(Yes) to apply your
d
Your machine will now try to connect to your
wireless network using the information you
have entered.
It may take a few minutes to connect to your
wireless network.
e
A connection result message appears for
60 seconds on the LCD and a wireless LAN
report will automatically be printed. If the
connection failed, check the error code on the
printed report and refer to Troubleshooting
on page 24.
Wireless setup is now complete. A four
level indicator at the top of your
machine's LCD will show the wireless
signal strength of your access
point/router.
To install MFL-Pro Suite, continue to
step 12.
®
For Windows
Users:
Now go to
Page 26
For Macintosh Users:
Now go to
Page 30