Brother DCP-L2535DW 제품 안전 매뉴얼 - 페이지 16

{카테고리_이름} Brother DCP-L2535DW에 대한 제품 안전 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother DCP-L2535DW 26 페이지. Brief explanations for routine operations
Brother DCP-L2535DW에 대해서도 마찬가지입니다: 참조 매뉴얼 (27 페이지), 빠른 설정 매뉴얼 (2 페이지), 빠른 설정 매뉴얼 (2 페이지), 빠른 설정 매뉴얼 (2 페이지)

페이지 인쇄

any 30 minute period for any single manual call initiation, and (b) The equipment shall go on-

hook for a period of not less than 30 seconds between the end of one attempt and the

beginning of the next call attempt.

11. Some parameters required for compliance with Telecom's Telepermit requirements are

dependent on the equipment (PC) associated with this device. The associated equipment

shall be set to operate within the following limits for compliance with Telecom's

Specifications: Automatic calls to different numbers are spaced such that there is no less

than five seconds between the end of one call attempt and the beginning of another.

12. This equipment should not be used under any circumstances which may constitute a

nuisance to other Telecom customers.

13. Some parameters required for compliance with Telecom's Telepermit requirements are

dependent on the equipment (PC) associated with this device. The associated equipment

shall be set to operate within the following limits for compliance with Telecom's

Specifications: Equipment shall be set to ensure that calls are answered between three and

30 seconds of receipt of ringing.

14. In the event of any problem with this device, it is to be disconnected, and a CPE item

connected to one of its terminal ports may be connected directly in its place. The user should

then arrange for the product to be repaired. Should the matter be reported to Telecom as a

wiring fault, and the fault is proven to be due to this product, a call-out charge will be

incurred by the customer.

15. Many CPE devices have features such as 'last number redial' or 'memory dial' which depend

on a small on-hook line current for the maintenance of memory information. Such terminal

devices used with the series connected device may lose their memory functions.

16. Telepermitted equipment only may be connected to the EXT telephone port. This port is not

specifically designed for three-wire-connected equipment. Three-wire-connected equipment

might not respond to incoming ringing when attached to this port.

17. The caller ID telephone numbers which are displayed and stored in this equipment include

the caller's area code or cellular code but do not include the toll access "0" prefix. When

calling back it is necessary to add a "0" to the telephone number, or if the telephone number

is a local number, omit the area code digit. If the toll services of a service provider other than

Telecom are being used then a toll charge may be incurred if the "0" prefix toll access code

and area code are used.

18. The answer delay setting of this equipment shall not be set to less than the default setting as

this will destroy Caller ID information.

19. When using the Caller Line Identification incorporated in this device, verify the integrity of the

recorded digits prior to dialling.

IMPORTANT NOTICE (MFC models only)

Under power failure conditions, this telephone may not operate. Please ensure that a separate

telephone, not dependent on local power, is available for emergency use in emergencies.