AEG 949 597 894 00 사용자 설명서 - 페이지 21
{카테고리_이름} AEG 949 597 894 00에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG 949 597 894 00 28 페이지.
페이지 인쇄
clean the filter. The notification stays on
for 30 seconds after you deactivate the
hood and the hob. The notification does
not block the use of the hob.
WARNING!
An oversaturated filter can pose a risk of
fire.
Disassembling / reassembling the filter
The filter and filter housing are located right
under the grid in the centre of the hob.
Remove them carefully as they might be
slippery due to accumulated grease.
1. Remove the grid.
2. Take out the filter housing.
3. Gently push the two elements from the
outside in and fold them together. Then
take out the filter from the filter housing.
4. Reassemble the filtering unit after
cleaning:
a. Slide the filter elements inside the
filter housing along the built-in
runners.
b. Place the filter housing back inside
the hood cavity.
Cleaning the filter housing
Wash the filter housing manually using a mild
detergent and a soft cloth. You can also wash
it in the dishwasher.
Cleaning the filter
1. Wash the filter in warm water using a mild
cleaning agent. You can use a soft
sponge, a soft cloth, or a non-abrasive
cleaning brush to remove food remains, if
necessary. You can also wash the filter in
a dishwasher at 65-70 °C (using a
program longer than 90 min), without
dishes in the same load.
2. Dry the filter in the oven for 20-30 min at
70 °C. Place the filter on the middle wire
shelf. Make sure to use a non-fan oven
function. Alternatively, you can leave the
filter to dry overnight at room
temperature. The filter needs to be fully
dried before reassembly.
3. Reassemble the filtering unit and put it
back inside the hood cavity.
4. If the notification
briefly to reset the counter.
The counter restarts.
is on, press
ENGLISH
21