Brother GT-3 Series 유지 관리 매뉴얼 - 페이지 8
{카테고리_이름} Brother GT-3 Series에 대한 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother GT-3 Series 17 페이지. Cookbook maintenance
Brother GT-3 Series에 대해서도 마찬가지입니다: 유지 관리 매뉴얼 (16 페이지), 사용 설명서 (15 페이지), 사용 설명서 (12 페이지), 사용 설명서 (18 페이지), 참조 매뉴얼 (8 페이지), 참조 매뉴얼 (8 페이지), 매뉴얼 (3 페이지), 설치 (4 페이지)
페이지 인쇄
MAINTENANCE PARTS EXCHANGE
> MAINTENANCE PARTS EXCHANGE PROCEDURE:
The 2 wiper cleaners , the fan filter, the flushing tray sponge and felt pads, and the
carriage felt pads need to be replaced in the MPE procedure.
The prompt to "Exchange Maintenance Parts" will occur after
80
(normal, powerful, or auto).
PH Cl.
Normally after this amount of cleanings, the wiper cleaner will be saturated to the point
where the wiper can no longer be cleaned.
When this happens, the nozzle plate will not be cleared and the nozzles may be blocked
or the firing may be misdirected.
Menu
>
Maintenance
It is important that you use this menu and not another one to replace MPE
!
parts because it will reset the internal counter to zero!
> WIPER CLEANER REPLACEMENT:
+
SPARE PARTS NUMBER:
> FAN FILTER REPLACEMENT:
AIR FLOW
+
SPARE PARTS NUMBER:
7
>
Maintenance Parts Exchange
SB3101001
The fan filter collects the mist from the print head spray from
the exhaust provided by the fan.
> Remember to place the new filter with the "Coarse" side in-
serted into the bracket.
> The air flow should enter the rougher side.
COARSE
FINE
SB3018001
>
OK
follow instructions and turn off printer
The Wiper Cleaner needs to be replaced reg-
ularly according to MPE or visual inspection.
Clean the Print Head Caps and Wiper Blade
before replacing the Wiper Cleaner !
EIGHTY
head cleanings