Brother GTX pro 설정 매뉴얼 - 페이지 13
{카테고리_이름} Brother GTX pro에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother GTX pro 40 페이지. Garment printer
Brother GTX pro에 대해서도 마찬가지입니다: 참조 매뉴얼 (13 페이지), 빠른 사용 설명서 (15 페이지), 사용자 설명서 (16 페이지)
페이지 인쇄
When installing the printer, avoid any place that presents
direct sunlight or a large amount of dust.
The body size is 55.1 in. (width) x 51.2 in. (depth) x 21.7 in.
(height) (140 cm (width) x 130 cm (depth) x 55 cm (height))
and the mass weighs 128 kg (282 lb).
Dimensions of the legs are 34.1 in. (86.7 cm) in width and
16.7 in. (42.3 cm) in depth. The diameter of the legs is 1.57
in. (40mm).
The height from the table to the top surface of the platen is
approx. 12.6 in. (32 cm).
Do not use an extension cable.
Ensure ample work space of over 39.4 in. (100 cm) in front of
and to each side of the printer is available. Also, as a space
to install the rear cover, keep 15.7 in. (40 cm) or wider space
in the back of the printer. Keep 17.7 in. (45 cm) or wider
space in the ceiling direction as well. As the air is exhausted
toward the rear side, keep 7.9 in. (20 cm) or more space from
the exhaust opening. If this space is not secured, you will
have to move peripherals or the printer when making a
repair.
The table that supports the printer should be at least 35.4 in.
(90 cm) in width and 23.6 in. (60 cm) in depth, and should be
able to bear a weight of 150 kg (330 lb) or more. The tabletop
should be horizontal and should not rattle when the printer is
running.
When installing the printer, place a level gauge on the top
surface of the cover and the top surface of the platen to
make adjustments so that the main unit is set horizontally.
In preparation for a major earthquake or other natural
disasters, fix the table and the main unit with a tool like a
fixing band to prevent the main unit from falling from the
table.
2
Unpacking
Do not turn on the power until "P.5 Removing
the protection materials" is completed.
IMPORTANT
Otherwise the printer may fail.
X0340
2