Brother GTX Series 참조 매뉴얼 - 페이지 4

{카테고리_이름} Brother GTX Series에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother GTX Series 13 페이지.
Brother GTX Series에 대해서도 마찬가지입니다: 참조 매뉴얼 (13 페이지)

DAILY AGITATION OF WHITE INK

> Perform the procedure shown below if the message "Remove the white ink cartridge

and shake it" is displayed before starting operation.

For 1 Minute

Take out the white ink cartridge from

the printer

Shake the cartridge horizontaly 100

times side by side to stir the white ink

> Repeat the same process on the other white ink cartridge! On the operation panel,

press

and the White Ink refilling will be performed automatically by the printer!

POUCH REPLACEMENT - VERY IMPORTANT !

Open the cartridge's lid on a flat surface and remove the empty pouch.

Unpack carefully a new ink pouch from its shipping carton.

Push the green tip end of the ink pouch into the cartridge until it clicks into place.

Straighten the ink pouch to align it with the gutter of lid of cartridge, and mount in posi-

tion inside the metal spring by pulling it with your hand.

If the edge of the ink pouch is bent or undulating significantly, make it straight and flat

with your hand to avoid wrinkles.

Place the pouch in a straight alignment with the cartridge. Align lines with each other!

Close the lid, verify if the spring is rolling to the front. Place the cartridge at around 45°

and push on the 2 upper metalic latches to add a bit more tension on the ink pouch.

Attach a shelf life sticker

CLICK

For 1 Minute

included with ink pouch onto the front of the cartridge.

ALIGN

When the remaining ink level becomes

approximately 15 cm, shake the cartridge

with its cover open and with the ink pouch

slightly winded, to make the ink easier to stir

NO WRINKLES

PUSH to ROLL