Brother HL-1000 Series 빠른 설정 매뉴얼 - 페이지 17

{카테고리_이름} Brother HL-1000 Series에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother HL-1000 Series 42 페이지. Brother hl-1040: quick setup

Action 7-3: Prepare Windows 3.1 for the Printer

You need to configure Windows 3.1 for the printer by installing the printer driver and

TrueType

-compatible fonts from the supplied disk into Windows 3.1.

Because the supplied printer driver and fonts are compressed on the disk, be sure to use the

supplied installer program to install them. These instructions assume you will install the

driver and fonts from the disk drive A.

1. Start Windows 3.1.

2. Insert the supplied disk for Windows into your floppy disk drive.

3. Choose Run from the File menu in the Program Manager.

4. Type the drive name where you inserted

the supplied disk and "SETUP" in the

box: for example, A:\SETUP. Click the

OK button or press the Enter key.

5. The installer program will begin. Follow the instructions on the computer screen.

(Be sure to restart Windows when the installation process is completed.)

NOTE

The installer automatically updates your SYSTEM.INI Windows file by adding

DEVICE=bi-di.386 under the [386Enh] section. If any bi-directional parallel

communications device driver has previously been installed, it will be deactivated by this

new driver. If you want to use the driver that was previously installed, you should re-install

your previous driver. However, re-installing the previous driver will make the HL-

800/1000 series driver inactive.

The installer makes the installed printer driver the Windows default.

The installer automatically sets the printer port to the parallel interface, LPT1.

During this installation, changes have been made to the SYSTEM.INI file. It is necessary

to restart Windows so that the changes become effective and the installed bi-directional

parallel communications device driver can take effect.

- 15 -