Brother HL-1040 빠른 설정 매뉴얼 - 페이지 26

{카테고리_이름} Brother HL-1040에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother HL-1040 42 페이지. Brother hl-1040: quick setup
Brother HL-1040에 대해서도 마찬가지입니다: 부품 참조 목록 (16 페이지)

페이지 인쇄

REPLACING THE TONER CARTRIDGE

The printer can print approximately 2,400 pages (5% coverage: A4/Letter) with one toner

cartridge. When the toner cartridge is running low, the Alarm and Data (Toner) lamps blink

once every 5 seconds to indicate toner low. Initially, some models are supplied with a

starter toner cartridge which must be replaced after 1,000 pages.

Note

Actual page count will vary depending on your average document type. (i.e.:

standard letter, detailed graphics, etc.)

It is recommended that you always keep a new toner cartridge ready for use for when

you get the toner low warning.

Discard the used toner cartridge according to local regulations. If you are not sure of

them, consult your local dealer. Be sure to seal up the toner cartridge tightly so that

toner powder does not spill out of the cartridge. Do not discard used toner cartridges

together with domestic rubbish.

It is recommended that you clean the printer when you replace the toner cartridge.

Caution

You may print approximately 100 pages after the first toner low indication. Both

Alarm and Data (Toner) lamps will blink continuously to indicate that the toner is

empty. Once this indication appears, your printer cannot resume printing until you

have installed a new toner cartridge.

Keep the drum unit level after removing the toner cartridge, to avoid

possible toner spill or scatter.

Follow these steps to replace the toner cartridge:

Toner Low and Empty Indication

Open the top cover towards you. Remove

the drum unit by holding each side of the

drum and gently lifting the drum forwards

towards you.

Note

It is recommended to put the drum unit on a

piece of disposable paper or cloth in case of

accidental toner spill or scatter.

- 24 -