AEG C88000M 설치 및 운영 지침 매뉴얼 - 페이지 27

{카테고리_이름} AEG C88000M에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG C88000M 33 페이지. Induction glass ceramic cooking surface

947344.book Seite 111 Mittwoch, 11. Juli 2001 2:15 14

Safety Instructions for the Installer

• This hob must be installed by qualified personnel, according to the

manufacturer's instructions and to the relevant country standards.

• In respect of fire protection, this appliance corresponds to type Y (IEC

335-2-6). Only this type of appliance may be installed with a high

cupboard or wall on one side.

• It is not permitted to fit drawers below the cooking surface.

• Protection against electric shock must be provided by the installa-

tion.

• The kitchen unit in which the appliance is fitted must satisfy the

requirements of DIN 68930 in respect of stability.

• Built-in ovens and cooking surfaces are fitted with special connector

systems. They may only be combined with appliances with a matching

system.

• All cut surfaces are to be sealed with a suitable sealant for protection

against moisture.

• On tiled work surfaces, the joints in the area where the hob sits on

the surface must be completely filled with grout.

• On natural, artificial stone, or ceramic tops, the snap action springs

must be bonded in place.

• Ensure that the seal is correctly seated in the frame and that it is sea-

ted against the work surface without leaving any gaps. Additional

silicon sealant must not be applied, this will make removal more diffi-

cult in the event of the need for service.

• To remove the hob, it must be pressed out from below.

• Connect the wiring harness plugs with the respective sockets of the

same colour of the built-in oven or switch box.

This induction glass ceramic cooking zone can only be combined

with the following AEG units:

Competence E 8. . .

Competence E 6. . .

Competence E 4106-1

Competence S 8. . .

Installation Instructions

111