Brother HL-1111 제품 안전 매뉴얼 - 페이지 14

{카테고리_이름} Brother HL-1111에 대한 제품 안전 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Brother HL-1111 25 페이지.
Brother HL-1111에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 사용 설명서 (7 페이지)

페이지 인쇄

MFC only

1 The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has

accepted that the item complies with minimum conditions for connection to its network. It

indicates no endorsement of the product by Telecom, nor does it provide any sort of warranty.

Above all, it provides no assurance that any item will work correctly in all respects with another

item of Telepermitted equipment of a different make or model, nor does it imply that any

product is compatible with all of Telecom's network services.

2 This equipment does not fully meet Telecom's impedance requirements. Performance

limitations may occur when used in conjunction with some parts of the network. Telecom will

accept no responsibility should difficulties arise in such circumstances.

3 If a charge for local calls is acceptable, the "Dial Button" should not be used for local calls. Only

the 7-digits of the local number should be dialled from your telephone. DO NOT dial the area

code digit or the "0 " prefix.

4 This equipment shall not be set to make automatic calls to the Telecom '111 ' Emergency

Service.

5 This equipment should not be used under any circumstances which may constitute a nuisance

to other Telecom customers.

6 Not all telephones will respond to incoming ringing when connected to the extension socket.

7 The answer delay setting of this equipment shall not be set to less than the default setting as

this will destroy Caller ID information.

8 All persons using this device for recording telephone conversations shall comply with New

Zealand law. This requires that at least one party to the conversation is to be aware that it is

being recorded. In addition, the Principles enumerated in the Privacy Act 1993 shall be

complied with in respect to the nature of the personal information collected, the purpose for its

collection, how it is to be used and what it disclosed to any other party.

9 This unit will only work in conjunction with a tone signalling (DTMF) telephone, but some

telephones are not compatible. Since noise or speech from the telephone can upset dialling

from this unit, errors may result if the devices are used together in other than quiet conditions.

10 Where it is necessary to dial prefix digits, such as a Caller Display override code ("0196 " or

"0197 "), this unit will have to be used in conjunction with an associated tone signalling (DTMF)

telephone.

11 Note that some telephones are not compatible with this unit and dialling errors may result if the

two devices are used together in other than quiet conditions. The Telecom Faults Service is

not to be called should such problems arise. In such cases, it is recommended that the prefix

and wanted number are dialled manually.

12 This equipment may not provide for the effective hand-over of a call to another device

connected to the same line.

13 This equipment is not capable, under all operating conditions, of correct operation at the higher

speeds for which it is designed. Telecom will accept no responsibility should difficulties arise

in such circumstances. This condition typically applies to 56 kbit/s modems and facsimile

products operating at >14.4 kbit/s.

14 When using the Caller Line Identification incorporated in this device, verify the integrity of the

recorded digits prior to dialling.