AEG GAS HOB 69802 G 사용 설명서 - 페이지 18

{카테고리_이름} AEG GAS HOB 69802 G에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG GAS HOB 69802 G 24 페이지. Electrolux cooktop user manual

Instructions for the Installer

Permanent Connection

In the case of a permanent connection, it is necessary that you install a double pole

switch between the hob and the electricity supply (mains), with a minimum gap of 3

mm. between the switch contacts and of a type suitable for the required load in

compliance with the current electric regulations.

The switch must not break the yellow and green earth cable at any point.

Ensure that the hob supply cord does not come into contact with surfaces with

temperatures higher than 50 deg. C.

Replacement of the cable

The connection of the voltage cable to the appliance's terminal block is of type "Y".

This means that its replacement requires the specific equipment of a technician.

In this case, only cable types H05RR-F, H05 V2V2-F (T90) or H05 BB-F must be

used. The cable section must be suitable to the voltage and the working temperatu-

re.

The yellow/green earth wire must be approximately 2 cm. longer than the phase

wires.

Wiring diagram

1. TAPS IGNITOR SWITCHES

2. IGNITOR UNIT

3. LED POWER INDICATORS