LG 22BK55WY 소유자 매뉴얼 - 페이지 11
{카테고리_이름} LG 22BK55WY에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. LG 22BK55WY 32 페이지. Ips led monitor
LG 22BK55WY에 대해서도 마찬가지입니다: 소유자 매뉴얼 (32 페이지), 소유자 매뉴얼 (32 페이지), 소유자 매뉴얼 (32 페이지), 소유자 매뉴얼 (32 페이지), 빠른 시작 매뉴얼 (8 페이지)
페이지 인쇄
Mounting on a wall
For proper ventilation, allow a clearance of 100
mm on each side and from the wall. Detailed
instructions are available from your dealer, see the
optional Tilt Wall Mounting Bracket Installation and
Setup Guide.
100 mm
If you intend to mount the Monitor set to a wall,
attach Wall mounting interface (optional parts) to
the back of the set.
When you install the Monitor set using a wall
mounting interface (optional parts), attach it
carefully so it will not drop.
1
Please, Use the screw and wall mount interface
in accordance with VESA Standards.
2
If you use screw longer than standard, the
monitor might be damaged internally.
3
If you use improper screw, the product might be
damaged and drop from mounted position. In
this case, LG Electronics is not responsible for
it.
4
VESA compatible only with respect to screw
mounting interface dimensions and mounting
screw specifications.
5
Please use VESA standard as below.
y
784.8 mm (30.9 inch) and under
* Wall Mount Pad Thickness : 2.6 mm
* Screw : Φ 4.0 mm x Pitch 0.7 mm x
Length 10 mm
y
787.4 mm (31.0 inch) and above
* Please use VESA standard wall mount pad
and screws.
100 mm
100 mm
100 mm
ASSEMBLING AND PREPARING
Model
22BK55WD
22BK55WY
VESA (A x B)
100 x 100
Standard screw
M4
Number of screws
4
CAUTION
y
Disconnect the power cord first, and then
move or install the Monitor set. Otherwise
electric shock may occur.
y
If you install the Monitor set on a ceiling or
slanted wall, it may fall and result in severe
injury.
y
Use only an authorized LG wall mount
and contact the local dealer or qualified
personnel.
y
Do not over tighten the screws as this may
cause damage to the Monitor set and void
your warranty.
y
Use only screws and wall mounts that
meet the VESA standard. Any damages
or injuries by misuse or using an improper
accessory are not covered by the warranty.
y
Screw length from outer surface of back
cover should be under 8mm.
Wall mount Pad
Wall mount Pad
Back Cover
Standard screw
NOTE
y
Use the screws that are listed on the
VESA standard screw specifications.
y
The wall mount kit will include an instal-
lation manual and necessary parts.
y
The wall mount bracket is optional. You
can obtain additional accessories from
your local dealer.
y
The length of screws may differ depend-
ing on the wall mount. Be sure to use
the proper length.
y
For more information, refer to the in-
structions supplied with the wall mount.
11
24BK55WD
24BK55WY
200 x 100
M4
4
Back Cover
Max.8mm