AEG IKE42640KB 사용자 설명서 - 페이지 7

{카테고리_이름} AEG IKE42640KB에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG IKE42640KB 20 페이지.
AEG IKE42640KB에 대해서도 마찬가지입니다: 사용자 설명서 (40 페이지)

3. INSTALLATION

WARNING!

Refer to Safety chapters.

3.1 Before the installation

Before you install the hob, write down the

information below from the rating plate. The

rating plate is on the bottom of the hob.

Serial number ...........................

3.2 Built-in hobs

Only use the built-in hobs after you assemble

the hob into correct built-in units and work

surfaces that align to the standards.

3.3 Connection cable

• The hob is supplied with a connection

cable.

• To replace the damaged mains cable, use

the cable: H05BB-F or H03V2V2-F which

withstands a temperature of 90 °C or

higher. Contact an Authorised Service

Centre. The connection cable may only be

replaced by a qualified electrician.

3.4 Attaching the seal - On-top

installation

1. Clean the worktop around the cut out

area.

2. Attach the supplied 2x6mm seal stripe to

the lower edge of the hob, along the

outer edge of the glass ceramic. Do not

stretch it. Make sure that the ends of the

seal stripe are located in the middle of

one side of the hob.

3. Add some millimetres to the length when

you cut the seal stripe.

4. Join the two ends of the seal stripe

together.

3.5 Assembly

min.

500mm

360

min.

50mm

min.

2mm

520

ENGLISH