AEG IPE64551FB 사용자 설명서 - 페이지 16
{카테고리_이름} AEG IPE64551FB에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AEG IPE64551FB 20 페이지.
AEG IPE64551FB에 대해서도 마찬가지입니다: 사용자 설명서 (24 페이지), 사용자 설명서 (25 페이지)
페이지 인쇄
7. CARE AND CLEANING
WARNING!
Refer to Safety chapters.
7.1 General information
• Clean the hob after each use.
• Always use cookware with a clean base.
• Scratches or dark stains on the surface
have no effect on how the hob operates.
• Use a special cleaner suitable for the
surface of the hob.
• Use a special scraper for the glass.
7.2 Cleaning the hob
• Remove immediately: melted plastic,
plastic foil, sugar and food with sugar,
8. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
8.1 What to do if...
Problem
You cannot activate or operate
the hob.
You cannot select the maximum
heat setting for one of the cook‐
ing zones.
16
ENGLISH
• Remove when the hob is sufficiently
• Remove shiny metallic discoloration:
Possible cause
The hob is not connected to an elec‐
trical supply or it is connected incor‐
rectly.
The fuse is blown.
You do not set the heat setting for
50 seconds.
You touched 2 or more sensor fields
at the same time.
Pause operates.
There is water or fat stains on the
control panel.
The other zones consume the maxi‐
mum available power.
Your hob works properly.
otherwise, the dirt can cause damage to
the hob. Take care to avoid burns. Use a
special hob scraper on the glass surface
at an acute angle and move the blade on
the surface.
cool: limescale rings, water rings, fat
stains, shiny metallic discoloration. Clean
the hob with a moist cloth and a non-
abrasive detergent. After cleaning, wipe
the hob dry with a soft cloth.
use a solution of water with vinegar and
clean the glass surface with a cloth.
Remedy
Check if the hob is correctly connected
to the electrical supply.
Make sure that the fuse is the cause of
the malfunction. If the fuse is blown
again and again, contact a qualified
electrician.
Activate the hob again and set the
heat setting in less than 50 seconds.
Touch only one sensor field.
Refer to "Daily use".
Clean the control panel.
Reduce the heat setting of the other
cooking zones connected to the same
phase. Refer to "Power management".